中圖分類號： TN86 文獻標識碼： A DOI：10.16157/j.issn.0258-7998.211628 中文引用格式： 饒剛，嚴帥,，金彬,，等. 100 W半橋LLC諧振變換器快速響應的控制策略設計[J].電子技術應用，2022,，48(2)：101-106,，110. 英文引用格式： Rao Gang，Yan Shuai,，Jin Bin,，et al. Control strategy design of 100 W fast response half bridge LLC resonant converter[J]. Application of Electronic Technique，2022,，48(2)：101-106,，110.
Control strategy design of 100 W fast response half bridge LLC resonant converter
Rao Gang，Yan Shuai,，Jin Bin,，Wang Wenjun
Hubei Key Laboratory of Mechanical Transmission and Manufacturing Engineering， Wuhan University of Science and Technology,，Wuhan 430081,，China
Abstract： For the dynamic characteristics of communication power supply when there is an inflow of big data traffic, a design of half-bridge LLC resonant converter based on variable universe fuzzy-PID control is proposed, which can realize the fast response control. Based on the traditional-PID control, it′s also adopted fuzzy mathematics and fast scalar multiplication algorithms that can help to improve the fast convergence characteristic of the system. Later, MATLAB/simulink software was used to simulate this strategy, compared with the traditional PID control scheme. Finally, an experimental prototype was designed for experimental verification. The experimental results show that the LLC resonant converter under variable universe fuzzy PID control has faster response speed and better dynamic characteristics.
Key words : variable universe fuzzy-PID control；half-bridge LLC resonant converter,；communication power supply,；dynamic characteristics
由于諧振電源器件參數固化,，其動態特性的提升多從控制回路著手,。文獻[4]通過對諧振電容兩端電壓進行分壓串取實現電流信息的采樣工作,，該種方案替代了電流互感器，但實現過程較為復雜,，對電壓電流的采樣精度有較高要求,。文獻[5]提出一種將變頻控制和移相控制相結合的控制方法，基于該種方法能實現變換器的寬電壓增益及全負載范圍的軟開關,，但控制環節較為復雜,，且PI環節的使用依舊存在控制回路對非線性負載跟隨性差的問題。文獻[6]依據軌跡控制需實時檢測輸出狀態的特性提出一種簡化的軌跡控制策略,，該策略在一定程度上消除了PID控制積分環節過大帶來的輸出過沖影響,，但在實際應用中受器件寄生參數及頻率的影響較大，而文中對此并沒有進行深入探討,。此外,，平均電流控制[7]、電荷控制[8-9],、脈沖寬度調制(Pulse Width Modulation,，PWM)與脈沖頻率調制(Pulse Frequency Modulation，PFM)混合控制[10]等控制方式在參數匹配的情況下對LLC諧振變換器的動態特性都進行了提升,，但在系統參數發生改變時,，上述控制方式將難以獲得理想的控制效果。
