《電子技術應用》
您所在的位置:首頁 > 微波|射頻 > 設計應用 > 一種G比特可變編碼調制的解調方法設計與實現
一種G比特可變編碼調制的解調方法設計與實現
2021年電子技術應用第6期
羅 強
西南電子技術研究所,,四川 成都610036
摘要: 隨著衛星通信技術的發展,,寬帶頻譜越來越少,,提高頻譜利用率就愈來愈重要,可變編碼調制技術(VCM)就是一種解決方案,。根據DVB-S2標準中對調制信號的格式的定義,,當調制方式在QPSK,、8PSK,、16APSK,、32APSK中切換時,幀頭和導頻仍然采用π/2BPSK進行調制,,基于此提出了對導頻和幀頭部分進行高碼率可變編碼的載波同步和均衡處理,實現結果表明,,能正常對不同調制方式進行解調,,同時保證在不同調制方式進行切換時仍能穩定完成解調,測試結果表明解調性能偏離理論值小于3 dB,,由于只采用了一種載波同步方法和均衡方法,,實現方法簡單,節省了FPGA資源,。
中圖分類號: TN927
文獻標識碼: A
DOI:10.16157/j.issn.0258-7998.201221
中文引用格式: 羅強. 一種G比特可變編碼調制的解調方法設計與實現[J].電子技術應用,,2021,47(6):126-130.
英文引用格式: Luo Qiang. Design and implementation of a demodulation method of G-bit variable coding modulation[J]. Application of Electronic Technique,,2021,,47(6):126-130.
Design and implementation of a demodulation method of G-bit variable coding modulation
Luo Qiang
Southwest China Institute of Electronic Technology,Chengdu 610036,,China
Abstract: With the development of satellite communication technology, the broadband spectrum is becoming less and less, so it is more and more important to improve the spectrum efficiency. The variable code modulation technology is a solution. According to the definition of modulation signal format in DVB-S2 standard, when the modulation mode is switched in QPSK, 8PSK, 16APSK and 32APSK, ?仔/2BPSK is still used for frame head and pilot. Based on this, a carrier synchronization and equalization processing based on pilot and frame header with variable coding rate is proposed. The results show that different modulation modes can be demodulated normally, while maintaining the same time. The test results show that the demodulation performance deviates from the theoretical value by less than 3 dB. Because only one carrier synchronization method and equalization method are used, which is simple and which saves the whole FPGA resource.
Key words : pilot,;variable code modulation;FPGA implementation,;high-speed data receiver

0 引言

    伴隨衛星通信技術應用的發展,,頻段資源越來越緊缺,提高頻帶利用率就越來越重要,。提高衛星過境期間總的傳輸數據量可以通過提高調制階數,,從QPSK提高到8PSK,進而到16APSK和32APSK可以明顯提高數據量,,調制階數越高對傳輸?shù)妮d噪比要求就越高,,而衛星過境期間的載噪比隨著衛星仰角的不斷增加而不斷提高,過頂后仰角的不斷減小而減小,。2005年,,歐洲電信標準化協會(European Telecommunication Standards Institute,,ETSI)頒布了新一代數字衛星廣播標準DVB_S2[1](Digital Video Broadcasting-Second Generation Satellite,第二代數字衛星廣播標準),。在此標準中增加了可變編碼調制(Variable Coding and Modulation,,VCM),此種傳輸方式可以根據衛星仰角的不斷改變相應地改變調制編碼方式,,在低仰角時采用QPSK調制方式,,隨著仰角的提高調制方式不斷改變?yōu)?PSK和16APSK,在接近過頂時載噪比較高,,可以采用32APSK調制方式,,這種VCM方式既保證在低仰角時能夠進行傳輸,又保證了高仰角時的數據傳輸速率,。

    傳統的DVB_S2解調均是低碼率的處理[2-3],,針對符號速率達到500 MS/s的高碼率的衛星接收處理方法并不多。




本文詳細內容請下載:http://forexkbc.com/resource/share/2000003587,。




作者信息:

羅  強

(西南電子技術研究所,,四川 成都610036)




wd.jpg

此內容為AET網站原創,未經授權禁止轉載,。